CAMSHAFT POSITION (CMP) SENSOR INSPECTION [MZ-CD 1.6 (Y6)]

id0140b2801400

Осторожно

•  Water penetrating the connector will cause sensor malfunction. To prevent this, be careful not to damage the wiring harnesses or the waterproof connector so as to cause water penetration.

Примечание

•  Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flowchart. (See ПОРЯДОК ИСПОЛЬЗОВАНИЯ ДАННОГО РУКОВОДСТВА.)

Visual inspection

1.  Remove the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION [MZ-CD 1.6 (Y6)].)

2.  Verify that there are no metal shavings on the sensor.

3.  Install the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION [MZ-CD 1.6 (Y6)].)

Voltage inspection

1.  Idle the engine.

2.  Measure the output voltage using a oscilloscope.

am3zzw00001593

•  If it is not within the specification, replace the CMP sensor. (See CAMSHAFT POSITION (CMP) SENSOR REMOVAL/INSTALLATION [MZ-CD 1.6 (Y6)].)

Circuit Open/Short Inspection

1.  Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION [MZ-CD 1.6 (Y6)].)

2.  Inspect the following wiring harness for an open or short circuit (continuity check).

am3zzw00001594

Open circuit

•  If there is no continuity, there is an open circuit. Repair or replace the wiring harness.

―  CMP sensor terminal A and PCM terminal 237

―  CMP sensor terminal B and PCM terminal 240

―  CMP sensor terminal C and PCM terminal 206

Short circuit

•  If there is continuity, there is an short circuit. Repair or replace the wiring harness.

―  CMP sensor terminal A and power supply

―  CMP sensor terminal A and body ground

―  CMP sensor terminal B and power supply

―  CMP sensor terminal B and body ground

―  CMP sensor terminal C and power supply

―  CMP sensor terminal C and body ground