MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR INSPECTION [MZ-CD 1.6 (Y6)]

id0140b2800900

Осторожно

•  Water penetrating the connector will cause sensor malfunction. To prevent this, be careful not to damage the wiring harnesses or the waterproof connector so as to cause water penetration.

Примечание

•  Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flowchart. (See ПОРЯДОК ИСПОЛЬЗОВАНИЯ ДАННОГО РУКОВОДСТВА.)

Visual Inspection

1.  Remove the MAP sensor. (See MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REMOVAL/INSTALLATION [MZ-CD 1.6 (Y6)].)

2.  Verify that there are no metal shavings on the sensor.

3.  Visually inspect the MAP sensor for the following:

•  Damage

•  Cracks

•  Rusted sensor terminal

•  Bent sensor terminal

―  If there is any malfunction, replace the MAP sensor.

4.  Install the MAP sensor. (See MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REMOVAL/INSTALLATION [MZ-CD 1.6 (Y6)].)

Voltage Inspection

1.  Turn the engine switch to the ON position (Engine off).

2.  Measure the voltage between MAP sensor terminal A and body ground.

am3zzw00001574

•  If it is not as specified, perform “Circuit Open/Short Inspection”.

―  If there is no open/short circuit, replace the MAP sensor.

3.  Start the engine.

4.  Measure the voltage between MAP sensor terminal A and body ground when applying boost.

am3zzw00001574

•  If it is not as specified, replace the MAP sensor.

5.  Stop the engine.

6.  Remove the MAP sensor, then connect the MAP sensor connector to the MAP sensor.

7.  Connect the vacuum pump to the MAP sensor.

8.  Turn the engine switch to the ON position (Engine off).

9.  Measure the voltage between MAP sensor terminal A and body ground when applying vacuum.

•  If it is not as specified, replace the MAP sensor.

Circuit Open/Short Inspection

1.  Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION [MZ-CD 1.6 (Y6)].)

2.  Inspect the following wiring harness for an open or short circuit. (Continuity check)

am3zzw00001575

Open circuit

•  If there is no continuity, the circuit is open. Repair or replace the wiring harness.

―  MAP sensor terminal A and PCM terminal 234

―  MAP sensor terminal Band PCM terminal 204

―  MAP sensor terminal C and PCM terminal 205

Short circuit

•  If there is continuity, the circuit is shorted. Repair or replace the wiring harness.

―  MAP sensor terminal A and power supply

―  MAP sensor terminal A and body ground

―  MAP sensor terminal B and power supply

―  MAP sensor terminal B and body ground

―  MAP sensor terminal C and power supply

―  MAP sensor terminal C and body ground