CLUTCH RELEASE CYLINDER REMOVAL/INSTALLATION [F35M-R, G35M-R, G66M-R, A26M-R]

id0510008013b5

Caution
•  Fluid will damage painted surfaces. Be careful not to spill any on painted surfaces. If it is spilled, wipe it off immediately.

1.  Remove the under cover.

2.  Remove in the order indicated in the table.

3.  Install in the reverse order of removal.

4.  Bleed the air from the system. (See CLUTCH FLUID AIR BLEEDING/REPLACEMENT.)

5.  After installation, inspect the clutch pedal. (See CLUTCH PEDAL INSPECTION.)

am3zzw00004278

1
Clutch pipe
(See Clutch Pipe Removal Note.)
(See Clutch Pipe Installation Note.)
2
Bolt
3
Clutch release cylinder


Clutch Pipe Removal Note

Caution
•  When disconnecting the clutch pipe, the seal ring installed to the end of the clutch pipe connector may fall off or remain on the clutch release cylinder side. If the clutch pipe is assembled with the seal ring not installed, it may cause fluid leakage from the clutch pipe connector or the clutch may not operate normally. When disconnecting the clutch pipe, remove the seal ring and clutch pipe connector as a single unit.
Note
•  A seal ring has been installed to the mid-connector between the clutch master cylinder and clutch release cylinder. Verify that the clutch pipe is removed together with the seal ring when disconnecting the mid-connector.
•  The O-ring type mid-connector seal ring is installed to the groove at the end of the clutch pipe.

1.  Pull the clip to the position shown in the figure and pull out the clutch pipe connector straight to detach it.

F35M-R

am3zzw00004279

G35M-R, G66M-R, A26M-R (L3 Turbo)

am3zzw00004280

A26M-R (MZR-CD (RF Turbo))

am3zzw00004284

2.  Verify that the seal ring is removed together with the clutch pipe connector.

am2zzw00003988


Clutch Pipe Installation Note

Note
•  A seal ring has been installed to the mid-connector between the clutch master cylinder and clutch release cylinder. Verify that a seal ring is installed to the clutch pipe when connecting the mid-connector.
•  The O-ring type mid-connector seal ring is installed to the groove at the end of the clutch pipe.

1.  Verify that the seal ring is assembled to the clutch pipe so that the ends of the seal ring and the clutch pipe overlap each other.

am2zzw00003961

Caution
•  Verify that there is no chipping or damage to the seal ring of the clutch pipe connector.

2.  Return the clip to the position shown in the figure.

F35M-R

am3zzw00004281

G35M-R, G66M-R, A26M-R (L3 Turbo)

am3zzw00004282

A26M-R (MZR-CD (RF Turbo))

am3zzw00004283

3.  Insert the clutch pipe connector straight.

4.  Pull the clutch pipe to verify that it does not come off, and reinsert it completely.