DTC P1675 [MZR-CD (RF Turbo)]

id0102f1838900

DTC P1675

Injector data not programmed
DETECTION CONDITION
•  The fuel injector compensation data configuration error
Diagnostic support note
•  MIL illuminates if PCM detects the above malfunctioning condition in one drive cycle and the DTC has been stored in the PCM.
•  FREEZE FRAME DATA is available.
•  DTC is stored in the PCM memory.
POSSIBLE CAUSE
•  Fuel injector compensation data input procedure does not been completed.
•  PCM malfunction

Diagnostic procedure

STEP

INSPECTION

ACTION
1
VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
•  Has FREEZE FRAME DATA been recorded?
Yes
Go to the next step.
No
Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
•  Verify related service repair information availability.
•  Is any related repair information available?
Yes
Perform repair or diagnosis according to the available repair information.
•  If the vehicle is not repaired, go to the next step.
No
Go to the next step.
3
VERIFY FUEL INJECTOR COMPENSATION DATA INPUT PROCEDURE
•  Does the fuel injector compensation data input procedure properly?
Yes
Go to the next step.
No
Perform the fuel injector compensation data input procedure.
(See FUEL INJECTOR REMOVAL/INSTALLATION [MZR-CD (RF Turbo)].)
4
VERIFY TROUBLESHOOTING OF DTC P1675 COMPLETED
•  Make sure to reconnect all disconnected connectors.
•  Turn the engine switch to ON position (engine off).
•  Clear the DTC from PCM memory using the M-MDS.
•  Start the engine.
•  Is the same DTC present?
Yes
Replace the PCM, go to the next step.
(See PCM REMOVAL/INSTALLATION [MZR-CD (RF Turbo)].)
No
Go to the next step.
5
VERIFY AFTER REPAIR PROCEDURE
•  Perform “AFTER REPAIR PROCEDURE”.
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [MZR-CD (RF Turbo)])
No
Troubleshooting completed.