DTC P0219 [MZR-CD (RF Turbo)]

id0102f1819600

DTC P0219

Engine overspeed condition

DETECTION CONDITION

• The PCM monitors the engine speed. If the engine speed is 6,000 rpm or more, the PCM determines that there is a malfunction in the control system.

POSSIBLE CAUSE

• PCM malfunction

DTC P0219	Engine overspeed condition
DETECTION CONDITION	• The PCM monitors the engine speed. If the engine speed is 6,000 rpm or more, the PCM determines that there is a malfunction in the control system.
POSSIBLE CAUSE	• PCM malfunction

Diagnostic procedure

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED • Has FREEZE FRAME DATA been recorded?	Yes	Go to the next step.
1		No	Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY • Verify related service repair information availability. • Is any related repair information available?	Yes	Perform repair or diagnosis according to the available repair information. • If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	VERIFY TROUBLESHOOTING OF P0219 COMPLETED • Make sure to reconnect all disconnected connectors. • Clear the DTC from the PCM memory using the M-MDS. • Start the engine. • Is the same DTC present?	Yes	Replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION [MZR-CD (RF Turbo)].)
3		No	Go to the next step.
4	VERIFY AFTER REPAIR PROCEDURE • Perform the “AFTER REPAIR PROCEDURE”. (See AFTER REPAIR PROCEDURE [MZR-CD (RF Turbo)].) • Is any DTC present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [MZR-CD (RF Turbo)])
4		No	DTC troubleshooting completed.