PCM CONFIGURATION [MZR-CD (RF Turbo)]

id0140f1802600

1.  Connect the M-MDS to DLC-2.

am3zzw00004061

2.  After the vehicle is identified, select the following items from the initial screen of the M-MDS.

•  When using the IDS (laptop PC)

1.  Select the “Toolbox” tab.

2.  Select the “Module Programming”.

•  When using the PDS (Pocket PC)

1.  Select “Programming”.

2.  Select “Module Programming”.

3.  Then, select the “Programmable Module Installation”, “PCM” and perform procedures according to directions on the M-MDS screen.

4.  Select “Programmable Parameters”. [with DSC HU/CM]

5.  Select “Tire Size / Axle Ratio”. [with DSC HU/CM]

6.  Select “Body Type - (PCM)”, then select the applicable body type on the M-MDS screen. [with DSC HU/CM]

Примечание

•  If the PCM is replaced with a new one, the PCM stores DTCs P0602 and P1675, illuminates the MIL even though no malfunction is detected. When the configuration is completed, DTCs P0602 and P1675 are cleared.

7.  Retrieve DTC’s using the M-MDS, then verify if DTCs are present.

•  If a DTC is present, perform the applicable DTC inspection.