GENERATOR REMOVAL/INSTALLATION [MZR-CD (RF Turbo)]

id0117f1800200

Warning

•  Remove and install all parts when the engine is cold, otherwise they can cause severe burns or serious injury.

•  When the battery cables are connected, touching the vehicle body with generator terminal B will generate sparks. This can cause personal injury, fire, and damage to the electrical components. Always disconnect the negative battery cable before performing the following operation.

1.  Disconnect the negative battery cable.

2.  Remove the under cover and splash shield as a single unit.

3.  Remove the drive belt. (See DRIVE BELT REMOVAL/INSTALLATION [MZR-CD (RF Turbo)].)

4.  Remove the A/C compressor with the pipes still connected. (See A/C COMPRESSOR REMOVAL/INSTALLATION [MZR-CD (RF-Turbo)].)

5.  Remove in the order indicated in the table.

6.  Install in the reverse order of removal

am3zzw00004454

1	Harness bracket
2	Terminal B cable
3	Generator connector
4	Generator (See Generator Installation Note.)

Generator Installation Note

1.  Tighten bolt A temporarily.

2.  Tighten bolt B to the specified tightening torque.

3.  Tighten bolt A to the specified tightening torque.